Home > Hard Drive > Hard Drive Woes- Bootable Sata Stuff?

Hard Drive Woes- Bootable Sata Stuff?


But, the good news is that usually only the write portion is affected if you run into a read/write issue. In other words, you’ll be able to recover all of that data still on your SSD and put it somewhere else. I know XMP is supposed to make stuff easier, but it just always caused me headaches. Staff Online Now crjdriver Moderator Drabdr Moderator dvk01 Moderator eddie5659 Moderator valis Moderator Noyb Trusted Advisor OBP Trusted Advisor askey127 Malware Specialist Advertisement Tech Support Guy Home Forums > Software & Source

It seems my Z170-PRO isn't as common of a motherboard as other ASUS Motherboards, So it's been a bit difficult at times finding other users of the same board. You can pick up an enclosure for between $20 to $50 on Amazon. This drive might be recoverable if you throw it in a freezer for about 2hrs (but try protecting it from condensation) throw it back in the pc right away, and if Did you ever find out what your possible problems could be? https://forums.techguy.org/threads/hard-drive-woes-bootable-sata-stuff.329611/

How To Make Ide Boot Instead Of Sata

The drive makes half-hearted whirring noises when you plug it in, then stops. Preview post Submit post Cancel post You are reporting the following post: Mixing SATA and IDE drives in a system? But - with such a new supercomputer this rarely is the reason… so just a idea to think about. I know that I used this disk in the past in a RAID (both in different ones), but this is long time ago and the disks working in this setup since

So can I remove the 2.5 inch drive and recover data with an enclosure? Search through over 5000+ Articles! © 2007 - 2016 groovyPost LLC | All Rights Reserved

Contact Us Blog Shop Drive Tracker Partners Work Order Request Help Request Help We would You can use drives individually. Make Hard Drive Bootable By morning the computer was back on the windows desktop.

I have Windows 2000 with an AMD 2800 chip and A7V8X mobo. Is there something I am missing here? The molex connector on the right is not exclusively “IDE Power.” Either power connector will carry the juice to your drive. https://www.pommepause.com/2009/11/fix-a-suddenly-very-slow-sata-hard-drive-problem/ That did happen to me once when I was switching between UEFI and Legacy boot modes.

Reply Jeff T on May 9, 2010 at 6:59 pm I have just recently received this error on startup when I enter setup the SATA 0 is blank and shows a Ide Drive to enable the partition or volume,restart the computor.) did the restart still no luck.question 1what is the best program to get back original files i had?question 2would it be best to Reply popop on November 23, 2008 at 2:46 am Just lost my first hard drive ever. Reply Scottie25 January 2017 at 13:26Permalink Yeah, this is why I tend to use the CSM anyway.

How To Connect Ide Hard Drive To Sata Motherboard

I was wondering if it was my computer (which is about a year and a half old at this point purchased from Seattle area firm Puget Systems. ) But those warning https://www.cnet.com/forums/discussions/mixing-sata-and-ide-drives-in-a-system-115142/ If it's a desktop or tower system you may well have 2 interface connection interface ports, and maybe just need a 3.00 adaptor from the older style power supply to the How To Make Ide Boot Instead Of Sata About CNET Privacy Policy Ad Choice Terms of Use Mobile User Agreement Help Center Scottie's Tech.Info A chimpanzee and two trainees could run her! Motherboard With Ide And Sata Ports Reply ThatSkyrimGuy on January 1, 2016 at 5:23 am Hey so I have had a dell inspiron 660 for a couple years now and it has an i5 3330 processor and

On the pic directly above, you can see the part on the power/cable end of the IDE drive that shows the pins where you make your jumper settings. this contact form And consider _ got given an I7 system that had stopped booting - drive seemed OK, memory seems OK, so that's either the motherboard £500, or the CPU £500, or the If you find out any good info, please let me know...thanx!Regards,Robert Flag Permalink This was helpful (0) Collapse - Sata is primary by edersch / July 28, 2005 9:26 AM PDT Then again if another drive goes, it should be a reasonable assumption that the drives can be reused - once you get a reliable PC. Which Portion Of The Bios Manages Essential Devices Before The Operating System Is Launched?

Be prepared to have essential tools such as a Torx 5 point screw driver and or flat head screw driver. Vivek David Mohyla February 7, 2013 3:06 pm Reply # Hi, Well your drive should appear in Disk Management much sooner then 30 minutes. and what I get... http://inc1.net/hard-drive/hard-drive-woes-seagate-external-500gb.html plz [email protected] Reply troy on May 23, 2013 at 8:19 pm iam building a dell 9300 up and I got all new hard were but the hard drive ok I keep

Get downloadable ebooks for free! Ide To Sata If so, and the prior format was a FAT version, then it may be possible to use a DATA RECOVERY program/App to read through the blocks on the drive, and recover Unplugged my IDE HD, booted off the Windows CD with only SATA drive plugged in and ran set up.

David Mohyla April 26, 2013 2:26 pm Reply # You may need to right click on the program icon and run them as an administrator.

Disk Management showed Disk0 as the SATA and Disk1 as the ST215A. So, it turned out that my hypothesis was correct. And the fun will just begin very soon. Reboot And Select Proper Boot Device I would then do a re-partition and reformat on the old drives.

Thank you for any advice you may offer. See if you can have the partition controls area re-written so the MFT (assuming it is not overwritten) can be read - again, some files will have had the content ‘deleted'. Moving along to how to fix all your New Motherboard Problems… Again, the following screenshots and instructions are specifically for an ASUS Z170-A motherboard, so your BIOS may vary. http://inc1.net/hard-drive/having-problems-booting-after-connecting-second-sata-drive.html Reply James September 18, 2016 at 12:03 pm # That depends - but first you should indicate to the list what your OS is - type, level and version.

secureadmin February 24, 2015 2:59 pm Reply # Ajay, Does it take a long time to display the folders? Part 1: How To Install a New Hard Drive, Pt 1. So please suggest me any solution. If the operating system uses Grub 2 and the boot loader was lost after a Windows installation (with the intent to dual-boot), there is a tool called Grub4dos, which can certainly

I was able to clean install Win 10 on new drive NVMe BPX MyDigital with GPT partion, but whenever I reboot, BSOD. Just before the 5 month mark I called Dell, they ended up sending me a new hard drive. Onto the next issue. Just wanted to check if these symptoms indicated some obscure virus before I play with the HD in another machine and possibly infect it.

There are a few tricks you can try that may get that machine booted.